| Step | | Procedure & Parts & Tools |
| 1 |
|
TURN MACHINE OFF
|
| 3 |
|
LOCATE THE DRAIN HOSES ON THE BACK OF THE MACHINE
|
| 4 |
|
PULL TO REMOVE THE HOSES FROM MACHINE. PLACE HOSE NEAR DRAIN AND REMOVE CAPS.
|
| 6 |
|
REMOVE THE 13MM TANK BOLT ON SIDE OF THE MACHINE. THIS BOLT IS LOCATED AT THE RIGHT FRONT OF THE MACHINE AT THE BASE.
| Ratchet-Socket metric 13mm |
|
|
| 7 |
|
LIFT THE TANK TO OPEN THE MACHINE
|
| 8 |
|
CHECK THE TIGHTNESS OF THE BRUSH MOTOR LEADS. REPLACE EYELETS IS DAMAGED. REPAIR WIRES IF DAMAGED.
| Wrench-Allen metric 5.0mm |
|
| Wrench-Allen metric 4.0mm |
|
|
| 9 |
|
AT THE FRONT OF THE MACHINE, CHECK THE MOTOR WIRES AT THE CONNECTION BLOCK. MAKE SURE THE COLORS MATCH AND THEY ARE NOT LOOSE.
|
| 10 |
|
CHECK THE MAIN HARNESS RUNNING UNDER THE FRAME, LOOK FOR NICKS/CUTS/BREAKS/ETC. REPAIR ANY DAMAGED WIRES, COMPLETE HARNESS NOT AVAILABLE FOR THE BRUSH MOTOR SYSTEM.
|